Traditional freestanding baths belong to many broad categories with regard to their general shape, two other conditions of equal importance will be the type of foot and also the kind of tap fittings required. Each one of these and also the main styles of traditional tub shape are described below. The info in this article is all about contemporarily manufactured traditional style freestanding baths not antique baths.
Traditional bath feet usually can be found in one of four broad styles even though the variation within those styles might be great. Plain feet, ball and claw feet, often just called claw feet have been in the form of a talon or claw gripping onto a ball which rests on to the ground and takes the load of the bath, lions paw feet are in the shape of the paw of an lion standing on the restroom floor and there are also various approximately Art Deco style feet you could find on a few freestanding baths. Of those three categories the ball and claw feet come in such wide variation that this more stylised versions are barely recognisable therefore with most of the detail gone. Plain feet are the same ball and claw normally shape but have no detail in it.
Bath feet are available in various materials and finishes, cast iron feet have to be painted, most often they’re painted black, white or even the same colour since the bathroom walls. Feet are offered also made out of brass, either which has a polished brass finish (that is utilized with gold taps) or in electroplated chrome, gold (usually called antique gold), brushed nickel or bright nickel. Its not all traditional baths have feet. Generally speaking feet aren’t interchangeable between baths even though they may sometimes be that exact manufacturers utilize the same feet on several of the baths. You shouldn’t buy a bath minus the feet until you know you may get the appropriate feet manufactured to the bath.
Its imperative that you know when you buy a conventional freestanding bath what type of taps you will use from it along with what you need to attractively plumb them in Traditional freestanding baths are usually called roll top baths, this means the rolling side of many traditional style of bath. It isn’t possible to mount a tap onto the rolling fringe of a roll top bath. A regular solution to this was to drill the taps hole from the side with the bath just over the overflow the taps used are shaped into the future up at right angles for the water inlet so they really come in the same form like a deck mounted list of taps. These taps are called globe taps, they generally come as a couple of taps, hot and cold. Globe taps are merely really used these days with antique certain roll top baths.
More generally nowadays roll top baths onto which taps could be mounted have what is known as a tap platform. A tap platform is often a flattened area of the bath edge into which tap holes can be drilled and taps mounted. For baths onto which taps can not be mounted you will employ either attached to the wall or floor mounted taps. Note that there are several contemporarily manufactured and, generally speaking, traditionally styled baths that don’t have a roll top consequently and onto which taps could in theory be mounted anywhere about the side of the bath.
More details about Freestanding Baths resource: read here.