Among the first things the do-it-yourselfer realizes when studying how to construct a drywall ceiling is that no man is surely an island – unless he uses rented equipment! Because the panels are big, bulky, and awkward, hanging drywall on the ceiling entails one or the other: the assistance of another person or renting a drywall jack from your local hardware store. The cable mechanism on drywall jacks just isn’t difficult to operate, and jacks do a great job of holding the drywall in a secure, flat position helping you to quicker attach it to the ceiling.
Tools & Materials
How to build a Drywall Installation diy includes understanding what all tools and material you may need. In addition to either another person to help you or a drywall jack, you’ll also require a hammer, a drill which has a screwdriver bit, and nails or screws for drywall. You’ll also, of course, have to measure your ceiling (twice!) and buy enough drywall, together with a little extra in the case of mistakes, to do the job.
Mark Joists First
Get the boards – usually 2x4s or 2x6s – that be ceiling joists by tapping along the wall studs which has a hammer and following inside the wall to the ceiling. As part of finding out how to create a drywall ceiling, mark where these boards are located which has a pencil. They are what will you be attaching the drywall to and marking them beforehand causes it to be better to locate them than attempting to find them while nailing or screwing on the drywall. After this you have to measure the place that the bulb continues on the drywall and cut out a hole to accommodate that area of the ceiling.
The Tough Part
Its part in mastering how to construct a drywall ceiling where you may need the other person (who hopefully has a lot of stamina in addition to strength!) to keep the drywall up to the ceiling in order to put the drywall panel on the jack. Position the end with the sheet of drywall – with its finished side facing down – at the center with the ceiling board (joist) which you will nail it. Nail across the outside the panel of a half an inch through the edges to prevent the drywall from splitting or cracking. The person who is holding the panel can move or, in case you are by using a jack, you can move out of how.
Make It Pretty
Countersink nails or screws at six- or seven-inch intervals all along the length of the joist which the drywall may be attached. Countersinking enables you to cover up the heads with the nails/screws with compound to ensure once you paint, the heads won’t be in any way visible. However, not really a a part of knowing how to create a drywall ceiling, finding out how to cover up ugly nail or screw heads serves its own purpose for overall general carpentry knowledge.
For more details about Drywall Installation diy just go to our site: click to read more