One of the primary things the do-it-yourselfer realizes while studying how to construct a drywall ceiling is the fact that no man is surely an island – unless he uses rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall on the ceiling entails either: assistance from someone else or renting a drywall jack from the local home improvement center. The cable mechanism on drywall jacks is not challenging to operate, and jacks do a great job of holding the drywall within a secure, flat position helping you to more easily attach it on the ceiling.
Tools & Materials
Developing a Drywall Installation diy includes being aware what all tools and material you’ll need. As well as either someone else to assist you or perhaps a drywall jack, you’ll also require a hammer, a drill with a screwdriver bit, and nails or screws for drywall. You will also, naturally, must measure your ceiling (twice!) and purchase enough drywall, with a little extra in the case of mistakes, for the task.
Mark Joists First
Find the boards – usually 2x4s or 2x6s – that work as ceiling joists by tapping across the wall studs with a hammer and following inside the wall on the ceiling. Included in learning how to build a drywall ceiling, mark where these boards are situated with a pencil. They are what you would be attaching the drywall to and marking them beforehand causes it to be better to find them than looking for them as you are nailing or screwing around the drywall. Then you definately must measure where the bulb continues on the drywall and eliminate an opening to accommodate that area of the ceiling.
The challenging Part
Now’s the part in learning how to construct a drywall ceiling where you’ll need the other person (who hopefully has lots of stamina as well as strength!) to carry the drywall to the ceiling or to position the drywall panel around the jack. Set the end with the sheet of drywall – with its finished side facing down – in the center with the ceiling board (joist) to which you are likely to nail it. Nail round the outside the panel about a half an inch through the edges to avoid the drywall from splitting or cracking. The one who is holding the panel can move or, if you’re utilizing a jack, it is possible to move it out of methods.
Make It Pretty
Countersink nails or screws at six- or seven-inch intervals all across the entire joist to which the drywall continues to be attached. Countersinking allows you to cover up the heads with the nails/screws with compound to ensure that when you paint, the heads will not at all visible. While not a legitimate part of finding out how to create a drywall ceiling, learning how to cover up ugly nail or screw heads serves its purpose for overall general carpentry knowledge.
To read more about Drywall Installation diy view this resource: click for more